IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

T38 Fax Across CUBE fails

Hi All I have see similiar threads on here about this issue but  i think my issue might be different. Call flow is Cisco ATA 190 --- SIP ----- CUCM ------ SIP ------ CUBE ------- SIP ------- ITSP I can see the initial Invites all flow between enpoint...

Calls disconnect on transfer

Hello I have an issue on a clients BE6000 CUCM where when they forward their phones to mobile everything works as expected. However when they transfer the call to external, the call disconnects after a few secs.   Basically flow is: External Caller >...

8821 Does not Ring when in Dock

I have a 8821 on CUCME 12.0. It is running the latest firmware: 11-0-3SR6-15   When the phone is in the cisco desktop charger the phone does not play the ring tone. The screen indicates there is an incoming call, and you can answer the call, but no s...

galbitz by Beginner
  • 7 replies
  • 0 Helpful votes

Display Desk IPPhone number on Forwarded mobile instead of Originator

Hi   External Caller --> VG (MGCP) --> CUCM --> IPPhone -- ForwardAll --> Personal Mobile   User forwards her line to a personal mobile number. when there is call on her DDI it gets forwarded to her mobile and on the display she gets the external cal...

Web access on UC560

Hi All Can anyone tell me how to access the web management tool on a cisco UC560 If I try to access it I just get a basic html page saying, show diagnostic log, monitor router etc, not the normal java based ccme based how to I get to it or enable it ...

CallForwardAll only works with MTP Required under SIP Trunk

Hello   Call flow: External Call Mobile1 -> SIP Provider -> CUBE (4431) -> CUCM (10.5) -> IPPhone (7841) which is set to forward all the call to a Mobile2 -> Same CUBE -> External Mobile2   Without MTP: When both Parties connect there is no audio, bo...