IP Telephony and Phones

Hello Everyone,   I have a problem were i have set up a MGCP Gateway With a FXO port for a customer, i have set it up so that when a call gets in, it gets delivered to an AA in unity connection, now the call gets connected fine but the issue i have i...

Is EM supported while connected via the anyconnect VPN.  I have EM working fine on phones inside the network, but when testing on a phone outside the network connected via the anyconnect VPN I get "Host not found". Thanks.

i see this problem happen frequently.  Does anyone recommend any steps to take to attempt to remedy this issue before escelating to ISP?  is there anything I can do to dig deeper or resolve the issue myself?     Router1#sh controllers t1T1 0/1/0 is u...

I need to change my ring topology using rep.   Problem with dhcp in client's ring structure client has a ring topology client has a ring topology, when we disconnect one side of the ring the dhcp does not work on some machines.   follows the attached...

Schama is: [ГТС] --PRI-- [Cisco2951,CME] --GRE Tunnel-- [Cisco 891] --LAN-- [Avaya IPO] There is a SIP Trunk Between CME and Avayadial-peer voice 1000 voip   description -= PSTN to Call Center | HQ CUCM1 =-   translation-profile incoming CCToPSTN_tp ...

What would be the difference between the 2 patterns above?  The digit strip of the 9 would be done on the CUBE in either case so wouldn't be using any digit dropping in the pattern.  

Hi all I need to block a numberfrom being dialled from our cucm to the outside, for example the number is 112233445566 How would I do this on the cucm and h323 pstn gateway? we use 9@ on cucm for outside calls on the gateway we have some translation ...

Hi  We have Cisco CUCM 10.x and Wireless IP phones at branch locations. Since Cisco wireless also centralized, branch APs are registered with centralized controller. APs are configured in flexconnect. Cisco 7925g are configured with simple open authe...

I have turn the feature control policy to use soft keys.  I also configured softkeys for abbreviated dialing for both on hook and off hook.   I can get the abbreviated dialing to work while on hook but I can not get this to work while off hook.  The ...

Hello,    I have 5 Voice-ports configured on a CME (1 PSTN and 4 FX0) and i have a extension range that goes from 100 to 120 and another from 200-220. I would like to only allow the range from 200 to 220 to use Voice-port's 0/0/1, 0/0/2 and 0/0/3.   ...

Hi, This one has got us into a challenge.  Is there way to get number ( only counts) registered devices ( all types) per devicepool or location from CUCM ? We are trying to monitor periodically the registration stats per location / devicepool. Since ...