IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Dial-peer failover

I have two CUCM servers and a cube router. I want to be able to route calls to 2nd server in the event 1st server is down but still pingable from the cube. It seems like cube is still sending calls to the failed server even though that server has som...

Hi there,   we're using CUCM V i'am trying to activate SSH connection on an IP phone which is done because i can now try to log with Putty and it is asking for a user/password. In CUCM in device > Phone  I did change the Secure Shell ...

simvoy by Level 1
  • 5 replies
  • 0 Helpful votes

Hi all,   I have a Voice gateway Cisco 4331 in which already 7 T1s are configured with high preference dial-peers for PSTN calls.My new requirement is to add 2 DID ranges 1XXX & 7XXX, I will configure these T1s on new interfaces. Now if anyone from a...

I have replaced some older model phones with the 8841 series phones. The older phones had the iDivert feature as a softkey. I am trying to create an iDivert softkey to mirror what these users had previously on the 8841. I have managed to get a "Decli...

Hello Community,   I am trying to understand how to apply a Caller name so all calls to specific number we have appear as a caller name not a number on the phones.   Would we simply just apply this on the line or does it need to be done elsewhere? I ...