IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

I need to reinstall a fresh copy of cucm on an existing CUCM VMware build - test lab . Though it is installed I need to rebuild it again, I thought the way to do it was the same as build   Point the drive to location of the bootable SW Power on And i...

iptuser55 by Frequent Contributor
  • 9 replies
  • 0 Helpful votes

There is my problem.   After setup and working fine for days all Cisco IP Phone 7975 now starting ringing the sametime in all extensions. Each cisco ip phone 7975 has their own number and when they receive a call all phones ring.   Could someone poin...

FaSantos by Beginner
  • 1 replies
  • 0 Helpful votes

Dear Cisco Support community. We have call manager 11.01 and I want to update my 8865 phones to new 12.1 FW version and we also want to enable new 8832 conference phones.   Because of this I could see that we need newer device pack version as we alre...

csedlmeier by Beginner
  • 7 replies
  • 0 Helpful votes

Greetings,   Does anyone out there have a running deployment of Verint 11.x and CUCM 11.5.x?   We plan upgrading from CUCM version 9.1.2.x to 11.5.x but we need to be sure that we won't have recording issues on that version. Noted that BIB bridge doe...

Scelo by Beginner
  • 0 replies
  • 0 Helpful votes

Hi,   Can we make Hunt Pilot a DID? Because i am trying to make hunt pilot DID so that outside callers can call directly Hunt pilot number and then to Hunt list and to Line Group. In nutshell , It will act as a ccx. Is this possible?  

Sonam by Beginner
  • 4 replies
  • 0 Helpful votes