Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi We have CUCM 11.0 on production, we have mismatch in the IP Phones firmware We wanted to upgrade all the IP phones firmware to 9.2.1 While uploading the firmware on CUCM, we are getting following error as attached. Also, we have some IP Phones a...
Hi All, We are currently running CUCM version 9.1.2.15900-7 and have deployed Cisco 8961 phones with firmware sip8961.9-4-2SR2-2. We wanted to have the phone display on 24/7 and created a new Common Phone Profile specific for these phones and remo...
After Configuring Tomocat Multi-SAN Certificate configuration on CUCM and IMP Cluster I am still getting the following error message when trying to access any of the CUCM Servers from any browser : Security certificate issues "The security certific...
Hi, Can we terminate multiple SIP trunk on Single Ethernet Interface (using sub interfaces) from Service Provider on Cisco 4451-X CUBE? If yes, then what all would be the limitations/restrictions to implement the same. Regard's Anil
Dear Team, Kindly note that we are facing issues in inter site calls , from SfB to CME. Please note that all other calls , like internal,PSTN calls working well from SfB.Issue persits only for intersite calls,which is with the below call flow. Sf...
Hi, Is PVDM4 supported on 3900 series voice gateways? Regard's Anil
Dear Nipun Singh Raghav , I would like to directly dial the international extension after voice announcement or press"0" to perator. Do I need to modify the TCL script file for dial the internal extension.I cant find the way how to make it.Please kin...
Hi, We are looking to upgrade few cucm/cuc clusters from 9.1.2, 10.5.2 to either 11.5 or 12.0 anyone got any advice what version should we go for? thanks
Hello All, A customer requested that calls to one DN be routed to to other DNs, if not answered by the first number called. I set up a hunt group for 4 DNs (using a line group, hunt list and hunt pilot), which appeared to have worked but I observed...
Hi. Couldn`t configure call recording on 7821 and 7841. Latest firmware sip78xx.10-1-1SR2-1. Recording on the other models (7942, 8945, cisco ip communicator) works fine.CUCM 8.6.2.23900-10Zoom CallRec 5.1.4
Hi, Does anyone encountered the same issue regarding the Hardware Conferencing using SIP IP Phones for CME? Scenario: 1. Phone A calling Phone B 2. Phone A pressing Conference button and calling Phone C (Phone B is put on hold). Phone A tried t...
Hey guys,Just in the middle of a Jabber roll out at the moment, and we are doing softphone only deployment with Windows 7.The problem we are having is that when you plug in the USB headset, Windows automatically makes it the default audio device, and...
Hello, I am configuring PLAR to provide one touch solution to reach WebEx. My plan is to configured line 2 on all 6000 phones and assigned extension number 12345678 and set line test label "WebEx". I have tested it on few phones and its working as ex...
How to determine who dropped the call first in UCCX/CUCM
Hello for everybody I have CUCM 11.5 and two voice gateways connecting to PSTN ISR4431 and 3925E. For the outbound call I use Route List which contains two Route groups. Each Route Group contains SIP trunk to voice gateway. Today I tried to check red...
