Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I apologies for what is likely to be a very trivial question to many but I'm learning from the ground up! (sub terrain in fact) I have inherited a 2821 with CME installed. With that came a few 7970G phones and a 3750PS-S router. So a few basic o...
Hi experts! Very weird question and this is opposite to usual questions. But need your expertise guidance on how shall I achieve the target. Customer has PCCE environment and FAC implemented. FAC code when changed gets leaked & misused. We came wi...
Hi, the problem is sip is not registering.i have cisco ISR4321/K9 Cisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.4(3)S7, RELEASE SOFTWARE (fc3)show run: voice service voip ip address trusted list ipv4 212.34.224.205 ...
Hi I have a setup that uses both SIP and MGCP. My plan is to move to gateway entirely to SIP soon but for now I have to find a solution. So for now I have a SIP connection which is used for all outbound calls and I have a analog trunks for backup....
Dear all, I have sip trunk confiugred successfully to CUBE for an outgoing call. Receivng call is as follows: Someone call the no(14037881898) on ITSP-->send call to CUBE---siptrunk->CUCM then i want the call to be forwarded to autoattendant no(54677...
Hello, I was wondering what does the "service session" command under dial-peer voice do? I cannot find any info on any reference guides. Thank you!
Some phones (in same device pool) are displaying the time incorrectly. There is only one NTP source for whole network. Any ideas? Rich
We have an 8841 ip phone and our provider mentioned that we need the 3PC compliant firmware for them to support this phone. Does anyone know if the 3PC firmware is available/downloadable? Is it readily available/free, tied to Smartnet, or something...
Hi, When I am trying to load service activation page from Publisher, it’s not loading after selecting Publisher from drop down. Sub is working perfectly fine. I am getting error "Connection to the server cannot be established(Unknown Error)" CUCM Ver...
Hi all In my company we are managing a huge cluster, with thousand of users. Do you know if there are some way to change the default filter on "user management --> End user" by default is set on "First name" and begins with. I would like to change ...
Dear Team,The BLF-SD light is always on one IP phone only. All the others are woking fine. Tried rebooting/reseting/reconfiguring the IP Phone, still no avail.Also the symbol on the IP Phone is a little different.Usually the symbol is a Phone on top ...
Hello Everyone, I am getting error in CUCM and related to License so i have to upload the license from Cisco Prime manager. Now, to resolve the issue, i need to upload the license in CUCM 10.5 version so please resolve the asked query. Can i uplo...
Scenario: Video call from IP phone 1 to IP phone 2. IP phone 1 (video)--->CUCM --> CUBE ---> CME---IP phone 2(video/DN4000) -------------------------------------------------------------------- Problem: CUBE remarks audio RTP packets from AF41 to EF ...
Does anyone know if IP Communicator will work on Apple Mac? We have CUCM 10.5.2 and are looking at this as a solution for remote call center agent access.
Upgraded from CUCM 8.6.2 to 10.5.2Now using CDR Analysis and Reporting in 10.5.2, I can not select the Local TimeZone.The pull down only shows UTC and GMT...In version 8.6.2 the pull down shows my LocalTimezoneAm i missing something?
