Hi All ,
i have CUCM 11.5 , System version: 11.5.1.12900-21. (Fresh Installation)
i am trying to change the IP Phone background image but can not see any PNG and List.xml file under TFTP File management.
Please advice.
My Call Manager is System version: 10.5.1.10000-7. We have auto-registration enabled. We have model CP-8861 phones that are not completing the auto-registration process. These are new models to our cluster and have never been added to our cluster ...
I'm having problems with the thumbnail images on a 8551 phone. According to the docs at www.cisco.com/c/en/us/td/docs/voice_ip_comm/cuipph/8811_8841_8851_8861/10_5/english/adminguide/P881_BK_A92A3B94_00_adminguide-8811_41_51_61-10_5/P881_BK_A92A3B94_...
Hi all, one of our customer is currently using CUCM 9.x and he wants to see the caller name for incoming calls instead of the caller number.
Simply, how can I do that for FREE?
Few notes (correct me if I'm wrong):
- I can't use CURRI because he is ...
Hi~
I've a 3845 voice gateway
The device has 18 E1 port.
when I command
card type E1 1 0
card type E1 1 1
card type E1 2 0
card type E1 2 1
card type E1 3 0
card type E1 3 1
card type E1 4 0
card type E1 4 1
they are good status.
I check controll...
Hello,
I have to make report used by each site that how many license it has used.
Is it possible in ELM/PLM that we can make license based on site usage ?
For ex. If i have site A,B & C and i want to know how many UCL basic, essential, enhanced l...
Hi All,
We are using CommSoft recording solution with CUCM-11.5. In current scenario only RTP portion of the call is getting recorded i.e audio portion.
Is it possible to record signaling portion of the call as well. i.e. We want to record the ca...
Hi;
I have installed a new CUCM (V. 11.5.1.12900)with a PUB and SUB. When i tried to make a conference from a phone, it shown, unable make conference. When i checked the software conference bridge which is fluctuating in between rejected,unregister...
I have a need to send a call to SIP_trunk_1 followed by SIP_trunk_2, and again SIP_trunk_1 if call fails to route, in order to match different dial-peer on CUBE1/GW1. My RL has GW1_RG, GW2_RG, GW3_RG where the GW1_RG and GW3_RG both point to SIP_tru...
We have CUCM version 10 and integrated with recording system( speechlog ) when the cucm which the ip phones registered on is down , the ip phones registered on the secondary node of its call manager group and after its first node come back up the pho...
hi there
consider we have a 2811 with cme
we have 20 ip phone and 1 sip trunk to pstn and 1 fxo port
first we want cme check the sip trunk and send the outbound call to sip trunk but when sip trunk is not available the 2811 use's his fxo port a...
