IP Telephony and Phones

I have basic CUCM experience and and wanting to know is there a simple way to set the MOH of a line group? I'm working on a system which is preset to play the same MOH for all users and groups within CM. What I want to do is give one unique line grou...

Hi all, We have a CME (C2851) with IOS 12.4(13r)T11, RELEASE SOFTWARE (fc1). A SIP Trunk is configured with ITSP. Calls work fine, inbound and outbound, however  typing the digits is not working eventhough we hear the tone when typed.IP Phones are C7...

We have a 2 server IM&P cluster version 9.1. High availability is enabled. I need to move the Publisher from an old UCS to new UCS machine. I have performed  a fresh install on the new hardware and then restore from a backup of the legacy publisher. ...

Hello,I'm using CUCM 6.1.2. Agent login Extension mobility on phone. They can press service button and enter user ID and PIN, when press submit, phone display show as login successful but phone extension not cahnge. I need to wait for a while, phone ...

hi I have 5 phone i need to configure it when i,m pichup the first phone the fourth phone start ringing 

Hi,We have a problem with Cisco 78xx and 88xx provisioned with Asterisk 1.8.21.0: When you are on active call and you receive another call, the second one continue to ring (many beeps ) which disturb the person on call.Normally, it should beep only o...

Can anyone confirm the regulatory requirements for emergency dialing in Brazil. Do we need a local gateway with either a POTS line or PRI for dailing emergency numbers just like in U.S in order to get the right number and location reflected to PSAP. ...

===========================================================Error message--Configuration validation with "PUBLISHER Host name" "IP address" failed Configuration first node "PUBLISHER Host name" is not a first node Is "PUBLISHER Host name" entered corr...

Hi, Can we set any email alerts on PLM so that we get alert when licenses are about to run out?

Dear Team, Please advise if it is possible to generate a report for usage of FAC’s.  Regards, 

Hi Experts, I would just like to share that recently we encountered an error on CIMC with fault code f0180 voltage related problem. (Please see attached image)I was able to clear the error by rebooting the server however we encountered this error not...