Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello Team, I was looking for some guide, or any link which can help me to understand the SME Dial plan structure in a multiple cluster. What is the role of SME, How to deploy the dial plan, how is the onnet and offnet calling works via SME Sam.
Hello, Can I bind IP address instead of Ethernet port in CUBE to accept incoming SIP calls I want to that CUBE gateway should accept the incoming calls from particular IP address and If the SIP calls coming from another IP will be rejected. Thanks
Dear All, We have two subscriber in HQ and Ter subscriber in Remote location. When we performing upgrade on Remote site , what are the prerequsite i need to consider?
hello. I am using Cisco router 881, CUCM 11.5, and cisco phone 7811. Can I add a prefix number in the voice gateway? or should i add it in CUCM? for example i want to add a "0" in front of the number. Because the incoming calls strip away the 0, i do...
Hi, Is there a way I can forward all calls from my desk phone (Cisco IP Phone - 7940) after 5pm until next day 9am every weekday? i. e while I am not at desk. Thank You Arun
Hi there! I have a cisco router as a WAN router, is my home gateway router. I set it like FXS & FXO gateway. I'm using it with asterisk and FreePBX. Now all looks great at works perfect, but talking about security some is really wrong with my config...
experts, Just try to get an idea. If we have 150k phone end points with total 120 sites What is the option to design the UCM 11.5 here. - do we need to use Super cluster to be single cluster ? or - install few UCM cluster & connect using SME ? ...
SIP provider is changing their IP addresses. Otherwise all port settings for both UDP and TCP are the same. I've updated the config with the new IP addresses. Inbound calls work. Outbound calls do not. Config attached.
I haven't done voice in a while. Now I have been asked to replace some routers that we have in the field. Do I need to order the voice bundle for the 4321 ISR, with a PVDM, if I'm only going to have one voip dial peer? Thanks, Scott
I had a request today to provide the ability for a user to listen to a local radio broadcast over their VOIP Phone. The local broadcast itself would be 'digitized' using a 3.5mm input into an FXO port and probably multicast broadcast from there. What...
Hello everyone, One of my client is planning to deploy Cisco BE6000M.As i checked the datasheets there were three models Cisco BE6000M,Cisco BE6000H and Cisco BE6000S. Is Cisco BE6000H/M a server platform and Cisco BE6000S a module to be integrated ...
We've amended a couple of the custom wallpapers for our IP phones on our TFTP servers. If we go to http://<CUCM>:6970/Desktop/.... to download the wallpaper, we get the new version. If we view the wallpapers on the handsets, it only shows the old ver...
Hi there. I´am wondering why there ist an "ANATEL" Sticker on the backside of my SPA509Gs? Are these phones branded oder flashed for a special telephone operator? Best regards, Nils
Hi, I am trying to configure the SSO on CallManager 10.5.2. I set the steps should correct, but I cannot found the IdP import on CallManager. Any idea?
Hello Guys, we have bought 7821 SIP phones but unfortunately they wont register unless on they are on the subnet as the CME.(tested and they register normally) i used session-transport tcp but the problem persists. Below is my CME version, configura...
