cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

83
Views
0
Helpful
0
Replies
Highlighted
Beginner

BE6000S deployment pressing <F2> or <F6> boot menu Invalid Password

Hi All

I am deploying a new BE6000S but the ESXi boots into a shell similar to this thread: https://supportforums.cisco.com/discussion/12566071/be6000s-comes-shell-prompt-instead-esxi-config-page

When I press <F2> or <F6> for Boot Menu it asks for a password. I have tried the CICM password but always returns an Invalid Password. How can I bypass this in-order to access the Boot Menu? I'm dead in the water here.

Regards,

Marcus

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here