01-07-2014 03:25 PM - edited 03-16-2019 09:08 PM
Hi,
I am trying to find out what is the best practice when creating dial-peer for analog lines on CME, should I use trunk group or create separate dial-peer for each FXO ports? If I use trunk group, is there any advantage ( lesser dial-peer) or disadvantage?
Thanks!
01-07-2014 03:33 PM
The advantage of trunk groups is that a single dial peer can point to for instance PSTN, rather then multiple dialpeers, with varying preference, each pointing to a separate FXO. Funtionally I can't see much difference. So I guess it also comes down to personal preference.
=============================
Please remember to rate useful posts, by clicking on the stars below.
=============================
01-09-2014 11:35 AM
what a bullcrap rating for that correct answer. Let me help fix it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: