Blocking specific incoming number MGCP CUCM 7

[Nishant Jethwa]

We have CUCM 7.1.5.20000-6 and use MGCP. As I recall 8 has a feature to block using translation patterns but not sure if this is possible using versions lower than 8.

So just looking to confirm if CUCM 7.1.5.20000-6 using MGCP can block a call based on the calling party number.                  

[Rob Huffman · Accepted solution]

Hi Nishant,

You are most correct my friend, with MGCP you need a minimum

of CUCM 8.x

From Dan @ Cisco for MGCP

https://supportforums.cisco.com/docs/DOC-18367

Cheers!

Rob

"Talk about a dream
Try to make it real" 

- Springsteen

[Aman Soi · Accepted solution]

Hi ,

I think u are looking for Route Next Hop by Calling Party number .

regds,

aman

[Nishant Jethwa]

That's what I was afraid of.

Thanks for confirming - back to the drawing board!