10-17-2010 07:54 AM - edited 03-16-2019 01:23 AM
Dear all
I have an question , our customer has IPT network in central office and two srst router in branches ,the central office and branch have pstn line in their voice gateway and srst router
now the branch phone users registered to cucm7 by their mpls network
The customer tell me branch phone call pstn must use their local gateway, Does anyone can tell me how do i do this function
thanks a lot
10-17-2010 08:28 AM
You basically need to create a RG with the SRST router in there. Create a RL pointing to that RG and then a RP based on the dialing pattern. Make sure that you assign it to the right partition.
Should be very straight forward to do this.
Thanks,
Pashmeen Mistry
P.S : Please rate all posts and mark them answered if they are.
10-17-2010 12:12 PM
Hi GS,
Just to add a note to the good tips from Pashmeen (+5"P")
You may find this great doc helpful;
CUCM 7.x Dial Plan Design using Local Route Group
https://supportforums.cisco.com/docs/DOC-8363
Cheers!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: