Bri NT/TE Layer 2 Problem

[Mounir CHAGUER]

Hi,

i have probléme with Bri NT/TE, Layer 2 set from state "MULTIPLE_FRAME_ESTABLISHED" to "TEI_ASSIGNED" During the call after 2 mn.

this configuration of interface Bri

interface BRI0/2/0
no ip address
no ip mroute-cache
no logging event link-status
isdn switch-type basic-net3
isdn timer T310 30000
isdn point-to-point-setup

isdn incoming-voice voice
isdn sending-complete
isdn static-tei 0

ISDN BRI0/2/0 interface
        dsl 8, interface ISDN Switchtype = basic-ts013
    Layer 1 Status:
        ACTIVE
    Layer 2 Status:
        TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
    Layer 3 Status:
        0 Active Layer 3 Call(s)
    Active dsl 8 CCBs = 0
    The Free Channel Mask:  0x80000003

[Stuti Desai]

Could you collect output for "debug isdn q921" and post it. That will explain what is happening at layer 2.

[Mounir CHAGUER]

Sorry for delai, attached debugging isdn Q921.