cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
335
Views
5
Helpful
2
Replies
Michael Horton
Beginner

Cable-detect on VG204XM

I enabled cable-detect on one port of a VG204XM and cable-detect poll-timer 1 under Voice Service Pots. The alerts for connecting and disconnecting a phone are getting logged, but I would like to know how I can configure the VG to send SNMP alerts.  It really doesn't do me much good to use the cable-detect command if I don't get an alert when a cable gets disconnected or reconnected.  Any help I can get with this would be greatly appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions

This TechNote only mentions syslog output.
https://www.cisco.com/c/en/us/support/docs/wan/tdm/117878-technote-tds-00.html
I’d suggest configuring your Syslog server to raise an alarm when such a message is received.

View solution in original post

2 REPLIES 2
Nipun Singh Raghav
Cisco Employee

You can use the MIB locator to check if their is one for this purpose -
http://mibs.cloudapps.cisco.com/ITDIT/MIBS/MainServlet

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"

This TechNote only mentions syslog output.
https://www.cisco.com/c/en/us/support/docs/wan/tdm/117878-technote-tds-00.html
I’d suggest configuring your Syslog server to raise an alarm when such a message is received.
Create
Recognize Your Peers
Content for Community-Ad