Hi,
Does anyone know if it's ok to configure ethernet dual attachment using "bridge group" with the Call Manager Express ?...
Because I tried and the phones went "flapping" immediatly i.e. registered / not registered / registered / not registered....
When I shut one of both Giga Interfaces, Phones stay registered....
I wonder if CME is "compatible" with this kind of dual-attachment....
Any Idea ?
Thanks for your help....
Regards,
Christian.
I configured this :
!
bridge irb
!
interface GigabitEthernet0/0
description LAN Call Manager Express Port 1
no ip address
duplex auto
speed auto
bridge-group 1
!
interface GigabitEthernet0/1
description LAN Call Manager Express Port 2
no ip address
duplex auto
speed auto
bridge-group 1
!
interface BVI1
description LAN Call Manager Express
ip address 10.10.10.1 255.255.255.0
!
!
bridge 1 protocol ieee
bridge 1 route ip
!