cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

AMA-CUCM Troubleshooting: Best Practices for Reading Trace Files

170
Views
0
Helpful
3
Replies
Highlighted
Participant

call routing

 

Hi,

I have the following conditions.

  • Have sip trunk which is connected to remote non cisco pbx
  • And route group with two mgcp gateway on premise .

 

 

I need to achieve the following .

 

  • If the user calls calls must  go through  sip trunk . If sip trunk fails  need to use the second option

 

 

Thanks

 

 

3 REPLIES 3
Rising star

Re: call routing

You can create Route Group say RG_SIP in which you put the SIP Trunk to PBX, Create another Route Group with Two local MGCP GW. Create Route List and Put RG_SIP and MGCP Route Group. Use this in Route Patterns

 

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

Hall of Fame Cisco Employee

Re: call routing

VIP Advisor

Re: call routing

Make sure you use OOB options 'ping' on your sip trunk in cucm, so that if it goes out of service, it can successfully fail over to your mgcp gateway

Please remember to rate useful posts, by clicking on the stars below.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards