04-23-2014 03:36 PM - edited 03-16-2019 10:33 PM
Hi Friends,
I have been working on a SIP gateway that is configured to connect to a legacy Nortel vis PRI. That part is good (enough for now anyway).
My problem is with e911. We plan to have telco provide all SIP and then have a secondary SIP ITSP to provide e911 services because telco doesn't for whatever reason.
I have been able to test inbound and outbound using either the Telco SIP or the ITSP lines, but am unable to affect the outbound caller ID for a test route I have configured.
The call flow is as such:
Cell Phone -> Telco SIP -> SIP Gateway -> ITSP SIP -> Desk Phone (External to System)
I am unable to do anything to affect the Called-ID on that appears - every time I get my Cell Phone caller ID. Tried various translation rules, redirect, target, etc.
The reason I want to do this is to test e911, which I can't do if my cell phone Caller ID appears...
Any Ideas??
Thank you!
04-23-2014 10:35 PM
Hi,
You can configure the name and number globally on the emergency SIP trunk.
As below:
Caller Information
Caller ID DN | |
Caller Name | |
Maintain Original Caller ID DN and Caller Name in Identity Headers
Or you can play with the “Calling Party Selection” option.
Sid |
04-24-2014 01:38 PM
Hi Sid,
Thanks for the info. It looks like this may be advice directed towards CUCM, I forgot to mention this was in IOS on CME.
I actually didnt think to send it to a DN first so I will give that a shot.
Thanks!
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide