07-27-2010 10:29 PM - edited 03-15-2019 11:57 PM
Hello,
I've a CME 3.3 on cisco 1751-V (IOS 12.4..24c).
IN the router it's installed a vic 2 fxo where is connected one analogic line.
the related voice-port has the following configuration:
voice-port 1/0
translation-profile incoming ENTRANTI
no comfort-noise
cptone IT
connection plar opx 200
!
I'need to enable the caller-id on this port (for default it is disables) but the command is "unknown" and doesn't appears if I press the ? key for help.
this is the list of command displayed when I ask help
POP_CSN(config-voiceport)#?
Voice-port configuration commands:
battery-reversal Enable FXO battery-reversal detection
bearer-cap Specify the bear capability
busyout Configure busyout trigger event & procedure
comfort-noise Use fill-silence option
connection Specify Trunking Parameters
cptone Configure voice call progress tone locale
default Set a command to its defaults
description Description of what this port is connected to
dial-type Configure type of dialer for voice
disc_pi_off close voice path when disconnect with PI received
echo-cancel Echo-cancellation option
exit Exit from voice-port configuration mode
impedance Specifies the terminating impedance of the interface
input Configure input gain for voice
music-threshold Threshold for Music on Hold
no Negate a command or set its defaults
non-linear Use non-linear processing during echo cancellation
output Configure output attenuation for voice
playout-delay Configure voice playout delay buffer
pre-dial-delay FXO Pre-dial Delay
ring Number of rings
shutdown Take voice-port offline
signal The signaling type for the interface FXS or FXO
snmp Modify SNMP voice port parameters
station-id Configure station ID
supervisory Configure answer + disconnect supervision options
threshold Threshold [noise] for voice port
timeouts Configure voice timeout parameters
timing Configure voice timing parameters
translate Translation rule
translation-profile Translation profile
trunk-group Configure interface to be in a trunk group
any suggest?
Thanks in advance
Giancarlo
Solved! Go to Solution.
08-05-2010 07:23 AM
That card doesn't support CLID.
You need a VIC-2FXO-M2 for CLID support in Italy.
-Steve
08-05-2010 07:23 AM
That card doesn't support CLID.
You need a VIC-2FXO-M2 for CLID support in Italy.
-Steve
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide