Caller ID

[robert.horrigan]

I currently run VoIP between a number of sites. When I make a VoIP call, the caller ID ends up being the dial-peer prefix. Is there a way to send the callers phone number as well? I am running call manager 5.1 with a standard route pattern pointing to the remote router. Here's the basic config we run

!

dial-peer voice 265 voip

destination-pattern 265....

session target ipv4:xxx

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

!

dial-peer voice 267 voip

destination-pattern 267....

session target ipv4:xxx

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

!

dial-peer voice 298 voip

destination-pattern 298....

session target ipv4:xxx

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

!

dial-peer voice 429 voip

destination-pattern 429.....

session target ipv4:xxx

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

[b.hsu]

Display (Internal Caller ID) not accepting Unicode Characters

After downloading the Japanese Locale for THX and while trying to save the unicode name in display (Internal Caller ID)

on the line page,it is not able to save the unicode name and throws an error: "Update failed. DeviceNumPlanMap Display has invalid format. Max length is 30. Regular expression used to validate: ^[^]""%<>[&|{}]{0,30}$"

Workaround:

However if the unicode name is put only in the "Alerting name" on the same line page it accepts the same and throws no error. -->