02-18-2016 04:49 AM - edited 03-17-2019 05:57 AM
Dear Expert,
I have a trouble about the ATA190.
I could configure a static ip address to the ATA190 through Phone call.
Then, it could register on the CUCM (version is 10.5).
But, its ATA190 hadn't had a static ip address I configured.
I configured certainly it.
So, I'd like to configure a static ip address with ATA190 through the WEB UI.
I was access the WEB UI of the ATA190.
But I couldn't find a page to configure a static ip address of the ATA190.
Can I configure a static ip address with ATA 190 through the WEB UI ?
If yes, Is there its page anywhere ?
My ATA190's information is as follows;
-Model: ATA190, 2 FXS
-Hardware Version: 1.1.1
-Boot Version: 1.3.1 (Mar 28 2014 - 10:22:17)
-Firmware Version: 1.2.1 (004) Jun 5 2015
-Recovery Firmware: 1.1.0 (000)
-WAN MAC Address: 34:XX:XX:XX:XX:XX ( I was mask a MAC address)
-Host Name: ATA190
-Domain Name: (none)
-Serial Number: ABCZZZZZZ ( I was mask too)
-Current Time: Thu, 18 Feb 2016 12:14:20
-Time Zone: (GMT-08:00) Pacific Time (USA & Canada)
I am looking forward to hearing from you.
Best regards,
takuro.
02-18-2016 05:30 AM
You can but I don't remember the window which allows this. But the way I prefer is to used to static DHCP binding to allocate statis IP. This is the ideal way to go unless you have restrictions.
02-18-2016 01:50 PM
Dear Mohammed al Baqari,
Thank you for the reply.
That's a good idea!. I've never noticed.
I'll try that method.
Thank you for giving me a hand.
Best regards,
takuro.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide