cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
652
Views
5
Helpful
2
Replies
Highlighted

Can I configure a static ip address with ATA 190 through the WEB UI ?

Dear Expert,

I have a trouble about the ATA190.

I could configure a static ip address to the ATA190 through Phone call.
Then, it could register on the CUCM (version is 10.5).
But, its ATA190 hadn't had a static ip address  I configured.
I configured certainly it.

So, I'd like to configure a static ip address with ATA190 through the WEB UI.
I was access the WEB UI of the ATA190.
But I couldn't find a page to configure a static ip address of the ATA190.

Can I configure a static ip address with ATA 190 through the WEB UI ?
If yes, Is there its page anywhere ?

My ATA190's information is as follows;
 -Model:     ATA190, 2 FXS
 -Hardware Version:     1.1.1
 -Boot Version:     1.3.1 (Mar 28 2014 - 10:22:17)
 -Firmware Version:     1.2.1 (004) Jun 5 2015
 -Recovery Firmware:     1.1.0 (000)
 -WAN MAC Address:     34:XX:XX:XX:XX:XX ( I was mask a MAC address)
 -Host Name:     ATA190
 -Domain Name:     (none)
 -Serial Number:     ABCZZZZZZ ( I was mask too)
 -Current Time:     Thu, 18 Feb 2016 12:14:20
 -Time Zone:     (GMT-08:00) Pacific Time (USA & Canada)

I am looking forward to hearing from you.

Best regards,
takuro.

2 REPLIES 2
Highlighted
VIP Advisor

You can but I don't remember the window which allows this. But the way I prefer is to used to static DHCP binding to allocate statis IP. This is the ideal way to go unless you have restrictions. 

Highlighted

Dear Mohammed al Baqari,

Thank you for the reply.
That's a good idea!. I've never noticed.
I'll try that method.

Thank you for giving me a hand.

Best regards,
takuro.

Content for Community-Ad