Can I configure a static ip address with ATA 190 through the WEB UI ?

[Takuro Moriyama]

Dear Expert,

I have a trouble about the ATA190.

I could configure a static ip address to the ATA190 through Phone call.
Then, it could register on the CUCM (version is 10.5).
But, its ATA190 hadn't had a static ip address  I configured.
I configured certainly it.

So, I'd like to configure a static ip address with ATA190 through the WEB UI.
I was access the WEB UI of the ATA190.
But I couldn't find a page to configure a static ip address of the ATA190.

Can I configure a static ip address with ATA 190 through the WEB UI ?
If yes, Is there its page anywhere ?

My ATA190's information is as follows;
 -Model:     ATA190, 2 FXS
 -Hardware Version:     1.1.1
 -Boot Version:     1.3.1 (Mar 28 2014 - 10:22:17)
 -Firmware Version:     1.2.1 (004) Jun 5 2015
 -Recovery Firmware:     1.1.0 (000)
 -WAN MAC Address:     34:XX:XX:XX:XX:XX ( I was mask a MAC address)
 -Host Name:     ATA190
 -Domain Name:     (none)
 -Serial Number:     ABCZZZZZZ ( I was mask too)
 -Current Time:     Thu, 18 Feb 2016 12:14:20
 -Time Zone:     (GMT-08:00) Pacific Time (USA & Canada)

I am looking forward to hearing from you.

Best regards,
takuro.

[Mohammed al Baqari]

You can but I don't remember the window which allows this. But the way I prefer is to used to static DHCP binding to allocate statis IP. This is the ideal way to go unless you have restrictions. 

[Takuro Moriyama]

Dear Mohammed al Baqari,

Thank you for the reply.
That's a good idea!. I've never noticed.
I'll try that method.

Thank you for giving me a hand.

Best regards,
takuro.