08-24-2011 05:19 PM - edited 03-16-2019 06:40 AM
Dear All
Does any one know about 2N GSM gateway integration with CUCM 8X? What I am looking for is the integration using FXO /FXS / VG224 port.
GSM gateway used by Customer which currently connects to Siemens PBX using RJ11: http://www.2n.cz/en/products/gsm-gateways/analog/easygate/
I have found that there is another GSM gateway from the same company that can be connected to CUCM as a SIP device (http://www.2n.cz/en/products/gsm-gateways/voip/voiceblue-next/) But I am looking for a way to connect the existing
2N® EasyGate analog GSM gateway to CUCM using FXS/FXO/VG224 port.
Many Thanks
Joseph J
Solved! Go to Solution.
08-25-2011 02:20 AM
Hi Joseph
Looking at the box you quoted the interface is :-
This means you will need to use an FXO (2 wire) on the Cisco CUCM side.
I have seen many similar setups in th UK called MOBEX
You will need to create a gateway H323/MGCP where the FXO resides.
You will need to know the access codes/routes and what digits to send to the easygate.
HTH
Alex
08-25-2011 02:20 AM
Hi Joseph
Looking at the box you quoted the interface is :-
This means you will need to use an FXO (2 wire) on the Cisco CUCM side.
I have seen many similar setups in th UK called MOBEX
You will need to create a gateway H323/MGCP where the FXO resides.
You will need to know the access codes/routes and what digits to send to the easygate.
HTH
Alex
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide