cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
951
Views
6
Helpful
4
Replies

Cannot Complete Conference (ICT non-gatekeeper)

Hi All

We got two branches:

Site A is registered to CUCM 8.0.2 on HQ and have HW-CFB on site.

Site B is registered to CUCM 7.1.2 onsite and have HW-CFB as well.

We have an ICT (Non-Gatekeeper Controlled) between CUCMs.

When phone 1-A calls to phone 2-A with codec G.711u then press "confrn"

dial to Phone 1-B successfully but when press "confrn" softkey to join the calls

the phone shows "Cannot Complete Conference"

This happen only with phones on the site B reached through inter-cluster trunk

Any input will be appreciated!

debugus attached

4 Replies 4

I forgot,

The ICT have MRLG and

Media Termination Point Required checked

You need to send CUCM SDI traces from both cluster. Ensure the calling and calld number is present in the trace before you send over. Also ensure your trace level is set to detailed

Please rate all useful posts

"opportunity is a haughty goddess who waste no time with those who are unprepared"

Please rate all useful posts

I'd also check regions and CAC associated to all elements involved.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

Thanks both of you for your answers.

The fact is that the one branch is connected by DMVPN, and the another one is connected by MPLS.

So it was a routing problem.

When I press the conference softkey the DSP resource can't reach the IP phone.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: