cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2500
Views
5
Helpful
3
Replies

Cannot Connect SIP Softphone to CME 8.6

Dennis Topo Jr
Level 1
Level 1

Hello all....I'm having trouble connecting a 3CX SIP softphone (Windows) to my CME router- version 8.6. Router is 2851 ISR- all connected via a lan switch in my office. Connectivity is fine between the PC\softphone and the router.

I have successfully setup 3 SCCP phones (all Cisco) but I'm not too clear why the SIP softphone is having issues- I've Google and read quite a bit but maybe somebody can check my config-- I'm sure I'm missing something. Also, tried to get some debug info from various debug ccsip xxx commands, but the console is overwhelmed with lines of debug- nothing that stands out anyway. I am familiar configuring sip phones for Asterisk....as I have a working PBX up here...but not so much for CME\Cisco.

Here's my pertinent config sections---  like I mentioned, I have working skinny phones on the same CME system. I wouldn't need to specify phone loads and type and tftp paths for a simple sip softphone would I???     Thanks in advance....Dennis

voice service voip

allow-connections sip to sip

sip

!

!

voice register global

mode cme

source-address 192.168.0.254 port 5060

max-dn 5

max-pool 5

authenticate register

!

voice register dn  1

number 1041

name DenOffice3CX

label DenOffice3CX

!

voice register pool  1

id mac 94DE.802D.8921

number 1 dn 1

username 1041 password cisco

codec g711ulaw

1 Accepted Solution

Accepted Solutions

Nadeem Ahmed
Cisco Employee
Cisco Employee

Hello Dennis,

Just refer to this blog it has explain on 3rd party sip phones registration with CME config.

http://uc-b.blogspot.in/2011/07/cisco-cme-w-3rd-party-sip-phones.html


Br,
Nadeem 

Please rate all useful post.

Br, Nadeem Please rate all useful post.

View solution in original post

3 Replies 3

Nadeem Ahmed
Cisco Employee
Cisco Employee

Hello Dennis,

Just refer to this blog it has explain on 3rd party sip phones registration with CME config.

http://uc-b.blogspot.in/2011/07/cisco-cme-w-3rd-party-sip-phones.html


Br,
Nadeem 

Please rate all useful post.

Br, Nadeem Please rate all useful post.

Nadeem-- thanks-- nice outlined config in the blog! The main thing I missed was the registrar itself no being "turned on"!

sip

registrar server expires max 600 min 60    turns on the SIP registrar!

It became blatently evident when I issued a debug ccsip events and got this:

CCSIP_REGISTER:: Registrar is not enabled

Lesson learned- thanks again

Dennis

Friend....thanks for the post...it helped me extremely

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: