cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
973
Views
0
Helpful
3
Replies

Cannot get abbreviated dial to work, get "Number not Configured"

Andy Backus
Level 1
Level 1

I have read other posts but none of the recommended actions seem to work or apply (bug with index greater than 43, performed pub/sub restarts).  I cannot seem to find any configuration information other than defining the number for a given index  (used ccmuser for this) so I assume I am fine from that perspective.  I have entires using personal fast dial index locations 1,2,10,11.  CCM version is 7.0, phone is 7961G with load sccp41.8-4-1s.  

With the phone on hook, I hit the "1" key, the softkey "AbbrDial" shows, and I select it with the resultant error message "Number not Configured".  I have tried all indexes from 1 to 15 in the chance that the index is offset; no luck.

Any help or guidance to here would be appreciated.

Thanks

Andy

1 Accepted Solution

Accepted Solutions

Tracy Larson
Level 4
Level 4

Abbreviated dial only works for "Speed Dial" not "Personal Fast Dial"

View solution in original post

3 Replies 3

Tracy Larson
Level 4
Level 4

Abbreviated dial only works for "Speed Dial" not "Personal Fast Dial"

Tracy, that was it.  Thank you VERY much.

You bet!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: