Cannot telnet or ssh to new vg204xm

[Marc Reid]

I just installed 2 new VG204XM gateways that are functioning fine but I cannot telnet or ssh to them. I can only connect via the console port.

Their config was copied from a VG204 and then only the host name, ip, etc was changed to reflect the location I installed in.

How can I enable telnet or ssh on these 2 devices?

[Nadeem Ahmed]

please refer to below document

http://www.cisco.com/c/en/us/td/docs/routers/access/vg202_vg204/quick/vg2_4qsg.html

Br,

Nadeem

[Marc Reid]

This document has no information on enabling remote access at all.

I would like the CLI commands to configure outside of the initial setup.

[Paul Gaydos]

Marc,

Did you ever resolve with being able to SSH to your VG204XM?  I have one setup and working fine via telnet, but I want to disable telnet access and enable SSH for security reasons.  The standard CLI command of "transport input ssh" is not being accepted on the VG204XM.

Thanks,

Paul