03-05-2007 02:07 AM - edited 03-14-2019 08:18 PM
hi
i have 2 7825 ibm MCS's one for Pub and the other for Sub, and each one has 2 NICs, my question is how the config for the 2 NiCs should be? active-active?, acive-standby?
what about the IP's, should each NIC have different IP or same IP?!
please advise
03-05-2007 03:29 AM
Hi,
I think that the UC 5.X doesn't have NIC TEAM support. This is a Server feature.
Maybe in the next version.
tks
03-05-2007 07:09 AM
You can do active standby type nic failover.
From CLI, type the following command,
set network failover enable.
HTH
Sankar.
PS: please remember to rate posts!
03-05-2007 07:50 AM
so, do i need to configure an ip for the second NIC, or just when it becomes active it takes the primary ip automatically?
03-05-2007 08:28 AM
You only need the IP for the primary NIC. From my experience, once the failover is configured, the bonded nic assumes the ip of the nic with configured ip.
Sankar.
03-05-2007 11:02 PM
this what i have to make sure ... thanks and here is 5 !!
03-15-2007 03:38 PM
I also notices the mac address moved over as well, the mac address stays the same regardless of which nic is used.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide