Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
361
Views
11
Helpful
2
Replies

ccm5.1 installation on vmware

markoller
Level 1
Level 1

‎05-19-2007 07:20 AM - edited ‎03-14-2019 09:35 PM

Anyone out there have any tips on getting 5.x installed on a VMWare image. I am trying to set up a lab for testing apps?

Labels:
0 Helpful
2 Replies 2

Chris Deren
Hall of Fame
Hall of Fame

‎05-19-2007 08:02 AM

Make sure that you select the guest operating system as Red Hat Enterprise Linux 3, selct 2 GB of RAM, 72 Gig HD.

As the source use the DVD Drive or select the ISO if you are going to use iso instead.

That's it.

HTH,

Chris

Jon Nelson
Level 3
Level 3

‎05-19-2007 07:36 PM

In addition to what Chris said, CM 5.x will install natively in VMWare as well. It will tell you that it is not a supported platform, but install just the same.

The other issue that you are going to run into is that you need to install a license for CM and DLU's for devices. Talk with your local Cisco office about getting their VMWare image or possibly helping you out with licensing as Cisco licensing *typically* doesn't allow you to register VMWare MAC addresses.

Thanks,

Jon

Customers Also Viewed These Support Documents