cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

CCME, FXO, voice hunt-group: caller-id issue

lliska
Beginner
Beginner

Hello,

I have C1861E-SRST router with c1861-advipservicesk9-mz.151-4.M2.bin and CCME 8.6.

PSTN is connected on FXO port.

Incomming call is forwarded to voice hunt-group (99) with 2 extensions on the list (91, 92). Both phones (SCCP) ring simultaneously, any of them can pick up the call. This works fine.

Caller-id is enabled on voice port.

The issue is, that caller-id displays only on the first extension from the hunt-group list (91). On the other phone "unknown number" appears on the display.

Here is the config:

voice hunt-group 9 parallel

list 91,92

pilot 99

voice-port 0/1/0
no battery-reversal
cptone SK
connection plar opx immediate 99
impedance complex2

caller-id enable
caller-id alerting ring 4

When I change the order of listed extensions to:

voice hunt-group 9 parallel

list 92,91

the caller-id displays on the 92 extension.

I need the caller-id to display on both phones. Is there a solution for this?

Thank you for the help.

Lubomir

1 ACCEPTED SOLUTION

Accepted Solutions

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Have you tried using a shared DN instead?

That is more tested and reliable solution.

View solution in original post

3 REPLIES 3

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Have you tried using a shared DN instead?

That is more tested and reliable solution.

Thank you, Paolo, it works this way.

Lubomir

Thanks for the nice rating and good luck!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: