05-06-2009 05:49 AM - edited 03-15-2019 05:52 PM
Hi,
Ho users can setup their phone.
I've tried to use the http://IP_ADDR_/ccme.html , with a simple user account.But I always have the Admin Interface of the CCME.
Is it possible to end-user to personalize their ipphone using the web interface, even if there is no Cisco Unity Express.
Best regards
Solved! Go to Solution.
05-06-2009 07:36 AM
Yes, end users can make a variety of customizations as outlined here:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/gui/user/guide/cmegui_user.pdf
To ge to the user page rather than the regular admin page, you need to check the priveleges on the account. If they are listed as an administrator, then they will get the admin interface. If they only have user level privileges, then they will only get the user page.
I hope this helps! If you found this post helpful, please rate it.
Thanks,
John
05-06-2009 07:36 AM
Yes, end users can make a variety of customizations as outlined here:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/gui/user/guide/cmegui_user.pdf
To ge to the user page rather than the regular admin page, you need to check the priveleges on the account. If they are listed as an administrator, then they will get the admin interface. If they only have user level privileges, then they will only get the user page.
I hope this helps! If you found this post helpful, please rate it.
Thanks,
John
05-07-2009 12:28 AM
Hi,
I know what is the error when I've exprerienced the problem.
I've logged with an administrator account before, and the IE cookie have not been destroyed. So If I log into the GUI I still have the last interface (Admin Interface)
Thank U very much
Best regards,
Antra
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: