Hi Shikamarunara,
Hope all is well my friend
Maybe these new CUCM 8.6 parameters are playing havoc here;
New and Updated Enterprise and System Parameters
Enterprise Parameters
No new or updated enterprise parameters exist in Cisco Unified Communications Manager 8.6(1).
Service Parameters
To access the service parameters in Cisco Unified Communications Manager Administration, choose System > Service Parameters. Choose the server and the service name that the parameter supports. For some parameters, you may need to click Advanced to display the service parameter. To display the help for the service parameter, click the name of the service parameter in the window.
•
Enable Source IP Address Verification for Software Media Devices—Use this parameter to determine whether the source IP address of the Annunciator and Music On Hold servers are verified to be registered Cisco Unified Communications Manager nodes in the cluster. This parameter is applicable only when the enterprise parameter Cluster Security Mode is set to 1 (mixed mode).
•Disable G.711u-law (64 kb/s and 56 kb/s) and G.711a-law (64 kb/s and 56 kb/s) codecs—Disable these parameters to minimize use of transcoders during Consult Conference/Transfer when you use BIB Recording. When you disable both codecs, Cisco Unified Communications Manager will reference the Static Selection Table and select the next available codec that devices and applications support.
•Locations-based Maximum Bandwidth Enforcement Level for MLPP Calls—Use this parameter to determine the level of bandwidth restriction that Cisco Unified Communications Manager enforces for a location when bandwidth reaches the threshold of becoming oversubscribed.
•SIP V.150 Outbound SDP Offer Filtering—Use this parameter to set the SIP V.150 outbound SDP offer filtering option. This parameter determines whether the SIP trunk performs filtering on transmitted SDP offers to remove MER or pre-MER V.150 content. Valid values specify No Filtering (the SIP trunk does not perform any filtering on outbound V.150 SDP lines); Remove MER V.150 (the SIP trunk removes MER lines in outbound SDP offers; use this value to reduce ambiguity when a trunk is connected to a pre-MER V.150 Unified CM); or Remove Pre-MER V.150 (the SIP trunk removes any non-MER-compliant lines in outbound SDP offers; if your cluster is contained within a network of MER-compliant devices that are incapable of processing an offer with pre-MER lines, choose this value). This is a required field and the default is No Filtering.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/8_6_1/delta/delta.html#wp2139571
Cheers!
Rob
"Why not help one another on the way" - Bob Marley
