08-02-2011 04:24 AM - edited 03-16-2019 06:15 AM
Hi,
Is there configuration difference between the 2801 and 2901 routers? Same configuration does not work on the 2901 routers. We can not send outgoing calls from the fxo lines but we can send from the voip dial-peers. Any idea?
Thanks
08-02-2011 06:14 AM
Hi Blackswans,
did you crreate a pots dial-peer for the fxo?
Regards,
Sven
08-02-2011 06:28 AM
yes sure but the call is failing. also we can call from the analog phone if I use that line with an analog phone, no problem with the line.
09-13-2013 08:28 PM
Can you post the configuration and run some debugs?
deb voice ccapi inout
deb vpm signal
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
09-13-2013 09:54 AM
were you able to resolve the problem?
we are running into a similar issue
migrating form 2801s to 2901 and we can't make calls out of the FXOs
09-14-2013 02:29 AM
Hi,
can you receive calls on FXO or you have only issues with the outbound.
sometimes the analog phone is not a correct test for the cisco router. can you try to change the order of the pairs for the analog lines. sometimes it helps
HTH
Anas
please rate all the helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: