We have a Cisco 3925 configured with CME 7 and enabled with the UC module. The machine also has a PRI and some BRI cards.
Is the following possible; a ISDN call comes in the Cisco 3925 (does not hit CME yet), the call is routed to our SIP platform, the SIP platform routes the call back to Cisco 3925 and a phone configured in CME should start ringing.
Is this possible?
I know it sounds odd to do this, but there are internal reasons why the call needs to travel through the SIP platform and back to the Cisco.
ephone-dn 62 octo-line number 1054 label Grant name Grant
Whenever someone (external) dials 765727054 my extension starts to ring.
From what I remember, an incoming call from ISDN always matches this dial-peer 2000 first, then it goes matching for "virtual" (not sure what these are called) dial-peer which I did not manually create.
List of Matched Outgoing Dial-peer(s): 1: Dial-peer Tag=20157
After this my extension/phone rings.
So, I need to change this dial-peer 2000 to send the call to the SIP platform? How do I do that? The session target command does not work, since the dial-peer is marked as pots and not voip.