08-09-2016 05:32 AM - edited 03-17-2019 07:46 AM
Our Cisco 4321 is our CUBE router as well as it has 2 fxo ports (and one T1 no longer used).
I recently changed the router to be SSH rather than Telnet and setup user/passwords. when I did this the CUBE part for SIP termination is still working but the FXO ports are no longer registering. I've deleted the gateway in CUCM and readded it to the same affect.
What can I do to have them register (preferably without any down time of the router, it's routing to the Call manager, handing out DHCP to the phones as well as SIP trunks for outbound)
Solved! Go to Solution.
08-09-2016 07:29 AM
Hi Jason,
Domain name mismatch would impact MGCP registration as you just found out, for future MGCP registration issue you can take the below debug for troubleshooting
debug ccm-manager config-download
debug ccm-manager errors
debug ccm-manager events
JB
08-09-2016 07:06 AM
Hi Jason,
Can you provide output for below
Show ccm-manager
Show mgcp endpoint
JB
08-09-2016 07:26 AM
I figured this one out.. when I setup SSH I of course had to set the domain name for the cert so instead of VGW_RTR as it's hostname for MGCP it would be VGW_RTR.DOMAIN
Anyway changed that in CUCM and it worked.
08-09-2016 07:29 AM
Hi Jason,
Domain name mismatch would impact MGCP registration as you just found out, for future MGCP registration issue you can take the below debug for troubleshooting
debug ccm-manager config-download
debug ccm-manager errors
debug ccm-manager events
JB
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide