I am officially stumped. I am running IOS 15.1, and CME 8.6 on my 2911. I have my CME router inside my main network (WatchGuard Firewall), and one of the interfaces on the CME router set as a WAN connection. My phones are also plugged into the WatchGuard network. I also have DHCP option 150 set in my WatchGuard router pointing it to the CME router, so the TFTP address is correct. (Basically, phones talk outside of the CME router).
When I first setup and configured the CME, everything works fine, phones register fine, and everything is great. After saving the config and rebooting the router, no phone will register to the CME router. They will pull TFTP files, firmware, SEP<MAC_ADDRESS>.cnf.xml files just fine, but they just get stuck saying "Registering" on the phones.
The phone can talk to the CME router, the CME router can talk to the phone, if I look under the phone's settings, all of the settings are correct. (Valid IP, Correct TFTP server IP, Correct Unified CM 1 Server IP, correct firmware, no error status messages).
I have even pulled the TFTP files manually using TFTPD from the router and inspected the configuration files, nothing stands out. No weird IPs, no weird ports, nothing.
I am stumped. This happens every time I reboot it. (I have reset the configuration and started from scratch twice, still with the same results).
I have even tried putting the phone inside of the network, still no luck.
Any suggestions are appreciated. Thanks.
Edit: I have tried manually creating cnf-files. No luck. And the time is incorrect on my router, so ignore the dates from 2002
Configuration:
show run
Building configuration...
Current configuration : 4288 bytes
!
! Last configuration change at 21:48:53 Eastern Sun Dec 18 2022
version 15.1
service config
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname hsl-cme
!
boot-start-marker
boot-end-marker
!
!
! card type command needed for slot/vwic-slot 0/0
enable password <YOU DON'T NEED THIS LOL>
!
no aaa new-model
!
clock timezone Eastern -5 0
!
no ipv6 cef
ip source-route
ip cef
!
!
!
!
!
!
multilink bundle-name authenticated
!
!
!
!
!
crypto pki token default removal timeout 0
!
!
voice-card 0
!
!
!
voice service voip
no ip address trusted authenticate
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
sip
!
!
voice register global
mode cme
create profile sync 0012570042340388
!
!
!
voice translation-rule 1
rule 1 /3238/ //
!
voice translation-rule 2
rule 1 /9\(.......\)/ /\1/
!
!
voice translation-profile SIPstrip
translate calling 2
translate called 2
!
voice translation-profile SIPto3DIGIT
translate called 1
!
!
license udi pid CISCO2911/K9 sn FTX1842ALHV
hw-module pvdm 0/0
!
!
!
!
redundancy
!
!
!
!
!
!
!
!
!
!
!
interface Embedded-Service-Engine0/0
no ip address
shutdown
!
interface GigabitEthernet0/0
ip address dhcp
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface GigabitEthernet0/2
ip address 10.0.0.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
!
ip forward-protocol nd
!
ip http server
no ip http secure-server
ip http path flash:/cme-gui-8.6.0
!
ip route 0.0.0.0 0.0.0.0 172.16.0.1 254
ip route 0.0.0.0 0.0.0.0 172.16.0.1 254
ip route 0.0.0.0 255.255.255.0 GigabitEthernet0/0
!
!
!
!
!
!
tftp-server flash:apps45.9-2-1TH1-13.sbn
tftp-server flash:cnu45.9-2-1TH1-13.sbn
tftp-server flash:cvm45sccp.9-2-1TH1-13.sbn
tftp-server flash:dsp45.9-2-1TH1-13.sbn
tftp-server flash:jar45sccp.9-2-1TH1-13.sbn
tftp-server flash:SCCP45.9-2-1S.loads
tftp-server flash:term45.default.loads
tftp-server flash:term65.default.loads
!
control-plane
!
!
voice-port 0/1/0
timing digit 50
timing inter-digit 50
connection plar 380
!
voice-port 0/1/1
!
voice-port 0/2/0
!
voice-port 0/2/1
!
voice-port 0/2/2
!
voice-port 0/2/3
!
!
!
mgcp profile default
!
!
dial-peer voice 100 voip
translation-profile incoming SIPstrip
translation-profile outgoing SIPstrip
destination-pattern 9.......
translate-outgoing calling 2
translate-outgoing called 2
session protocol sipv2
session target <YOU DON'T NEED THIS EITHER LOL>
codec g711ulaw
!
dial-peer voice 102 pots
destination-pattern 381
port 0/2/0
!
dial-peer voice 99 voip
translation-profile incoming SIPto3DIGIT
session protocol sipv2
session target <YOU DON'T NEED THIS EITHER LOL>
incoming called-num
codec g711ulaw
!
dial-peer voice 1000 pots
destination-pattern .%
port 0/2/0
!
!
sip-ua
credentials <YOU DON'T NEED THIS EITHER LOL>
authentication <YOU DON'T NEED THIS EITHER LOL>
registrar 1 <YOU DON'T NEED THIS EITHER LOL>
sip-server <YOU DON'T NEED THIS EITHER LOL>
!
!
!
gatekeeper
shutdown
!
!
telephony-service
max-ephones 15
max-dn 100
ip source-address 172.16.0.112 port 2000
system message HSL Research
cnf-file location flash:
cnf-file perphone
load 7945 SCCP45.9-2-1S.loads
load 7965 SCCP45.9-2-1S.loads
max-conferences 8 gain -6
web admin system name <YOU DON'T NEED THIS EITHER LOL>
dn-webedit
transfer-system full-consult
create cnf-files version-stamp Jan 01 2002 00:00:00
!
!
ephone-dn 1
number 380
label Line 1
description 380
name <YOU DON'T NEED THIS EITHER LOL>
hold-a
!
!
ephone 1
device-security-mode none
mac-address 5897.1E28.50C6
speed-dial 1 <FORUMS DON'T LIKE PHONE NUMBERS> label "P-Star CSM"
type 7965
button 1:1
pin 1379
!
!
!
!
line con 0
line aux 0
line 2
no activation-character
no exec
transport preferred none
transport input all
transport output pad telnet rlogin lapb-ta mop udptn v120 ssh
stopbits 1
line vty 0 4
login
transport input all
!
scheduler allocate 20000 1000
ntp server 132.163.97.5
end
