09-25-2018 07:41 AM - edited 03-17-2019 01:31 PM
Hello,
We're running CUCM 11.5 SU2 (11.5.1.12900-21) and installed the latest devpack (cmterm-devicepack11.5.1.16083-1.cop.sgn) in order to use the 8832 Conference Phone. We've just configured our 8832 and while the device comes up, and I can place calls from it, in the CUCM Web Admin GUI the status shows as none/none, as if it has never registered.
Has anyone seen this? I checked around and found bug ID CSCvj33740 but it doesn't seem to match in that we get a DHCP address, and it appears to be up and working from the user side.
09-27-2018 05:51 AM
Hi Joshua,
I think it may actually be this bug;
09-27-2018 03:09 PM
Further to Rob's reply, I've experienced the exact same thing with another new device pack on 11.5(1)SU2 and yes, a reboot of the cluster fixed it (not sure if a Callmanager service restart may have fixed it also but it was easier to just reboot in my case).
11-14-2018 07:27 AM
01-21-2019 11:59 AM - edited 01-21-2019 12:13 PM
Hello Joshua,
The documentation may be inaccurate in some places which is something that's going to be addressed eventually. You need to reboot the cluster in order the device pack to be applied correctly, which should resolve your issue.
Refer to step 12 under "Install a Device Pack or Individual Firmware" in the following documentation https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/11_5_1/Admin/cucm_b_administration-guide-1151/cucm_b_administration-guide-1151_chapter_0110.html#task_0579BAD0EFA1447FE2550BC549627C28
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide