Hello, I am a final user who´s traying to find out some source of knowledge for some issues I am facing with my new Cisco 8845 3PCC connected to an Issabel PBX/Asterisk.
I am coming from a “yeahlink” user experience, so It´s been quite a change in about how to config the phone, but instead of giving up with some issues, I would like to ask your advise about who to ask or where.
Thank you in advance for any assistance you can provide,
What's the software version running on these phones?
For specific issues you can contact TAC -
Auto resume a call when switching between lines - Currently the phone does not auto resume on pressing line keys. You can contact TAC from the above link to put in a feature request.
For speed dial - It's difficult to predict without looking at the logs but most probably the issue here is the Dial Plan. I would think the dial plan is blocking three digit * code's. Take a look at changing that and it should be fixed. The admin guide has examples for this.
For conference - Again the admin guide has more information on it. However you can change the soft key during active call to use confLx instead of conf. This should put the active lines in conference.
Bluetooth - We will need more logs and information on this. I would have to know what the current software version is to advice further. Contacting TAC would be good if it's a genuine issue.