03-21-2019 10:08 AM
I am trying to set up a Cisco 8800 KEM with an 8865 phone. I know with the old CUCM, you could create a template and push it to the key expansion module, but, with Control Hub, I see the KEM is attached but can't do anything with it. When its plugged into the phone, I get a white screen. I've tried a factory reset with no luck. Any ideas?
Solved! Go to Solution.
07-11-2019 12:35 PM
Just in case anyone is ever caught in a similar situation, it turns out that the 8800 KEM doesn't show anything on it until you fill all your speed dial slots up on the phone it is plugged into. It took me 5 months to get this answer, because nobody knew until I contacted Cisco support and even then, they didnt know until we tried a few things first and then stumbled upon this.
03-26-2019 02:24 AM
hi,
what you see on the phone web page >> status messages, when connect the KEM.
regards.
03-28-2019 11:29 AM
Not sure I quite understand. The phone itself shows the KEM installed, but the screen is white and the '1' is green. I checked in Control Hub and under my user\devices, it shows KEM:1. But, if I click on Devices in Control Hub and go to my phone, it does not show a KEM attached. I can send any screenshots you need. Any help would be appreciated since you are the first person to respond on this and I have spent many hours digging through the web.
thanks
Chris
07-11-2019 12:35 PM
Just in case anyone is ever caught in a similar situation, it turns out that the 8800 KEM doesn't show anything on it until you fill all your speed dial slots up on the phone it is plugged into. It took me 5 months to get this answer, because nobody knew until I contacted Cisco support and even then, they didnt know until we tried a few things first and then stumbled upon this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide