cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
344
Views
0
Helpful
0
Replies

cisco ATA 186 poor call quality and ping times

ciscokid6969
Level 1
Level 1

Hey i dont use ATA's much, except for faxing. However today i had to deploy one for a client and it failed miserably with horrible call quality. I was wondering if anyone knew why. First piece of evidence is that my ping time across the lan to these ATA's is 60-70ms ( time=65ms TTL=249 ), whereas desk phones like a 8841 are all 1ms. All computers on the lan are 1-3ms. Only the ATA's are poor quality pings and are on the same vlan as the phones so it doesnt make sense to me.

 

Below is the config i am using for the ATA's. Like i said, doesnt matter what switch on site i plug them into they are all doing the same thing. I have 6 ata's. For faxing it does not seem to matter, but for voice it does matter, which is why i never noticed the call quality problems before.

 

description "manually configured ATA"
 switchport mode access
 switchport block unicast
 switchport voice vlan 2
 switchport port-security maximum 3
 switchport port-security maximum 2 vlan access
 switchport port-security violation  restrict
 switchport port-security aging time 1
 switchport port-security aging type inactivity
 switchport port-security
 load-interval 60
 power inline auto max 15400
 srr-queue bandwidth share 1 30 35 5
 priority-queue out 
 mls qos trust device cisco-phone
 mls qos trust cos
 no macro auto processing
 auto qos voip cisco-phone 
 storm-control broadcast level pps 1k
 storm-control multicast level pps 2k
 storm-control action trap
 nmsp attachment suppress
 spanning-tree portfast
 spanning-tree bpdufilter enable
 spanning-tree bpduguard enable
 service-policy input AUTOQOS-SRND4-CISCOPHONE-POLICY
 ip dhcp snooping limit rate 15

a traceroute is one hop to our nexus router.

 

Any ideas? Is it because they are all running at 10mbps half duplex? is it a codec issue?

Gi1/0/47  " manually configur connected    1          a-half   a-10 10/100/1000BaseTX
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: