cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
670
Views
0
Helpful
3
Replies

CISCO CM qsiq PRI with legacy PBX, how to.

antonello.moneta
Beginner
Beginner

Hello to everyone,

I have to link an legacy pbx (oxo) with a cisco CM. I know there is the posibility to connect them by a pri with qsig.

Can everyone address me ?

Thank you really much

3 Replies 3

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Do you have any experience in this field? If you don't and/or have no certifications, you best choice is to engage a reputable consultant, or certified Cisco partner.

Hello Paolo,

I am not a voice specialist, but I have several year of experiences in  networking. I never configured this kind of trunks, but I installed  severals CME and CM. I am not a total newbe. I need some documentation  where I can find how to make this link, I am a self confident I think I  can manage this installation, of course I if I cannot managed that, I  will call a voice specialist; but I would like to try.

Please Paolo, let me if you know any documentation about this issue.

Thank you.

I would start reading CUCM documentation and SRND, then a search here and on cisco.com.

The matter has been discussed so many times, that unless you have very specific issues, doesn't deserve a new thread again.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: