09-21-2012 02:33 AM - edited 03-16-2019 01:19 PM
Hi
I am trying to register e20(vTE4.1.1.273710) to CUCM(8.6.1)
Is auto-reg works correct with E20? Because i couldnt do.
And When i try to register with manuel-reg option, depent on this steps https://supportforums.cisco.com/message/3299316#3299316 ,
Device Information page looks like this
Registration | Rejected |
IP Address | 10.200.80.133 |
Active Load ID | Unknown |
How can i register my e20 to Cucm?what is the reason of status and SIP id issues.
Thanks
Kaan
09-21-2012 10:41 AM
Hello
This discussion might help you!
https://supportforums.cisco.com/thread/2094064
Regards
Leonardo Santana
09-24-2012 02:01 AM
I solved.The problem is the Dns fault. Registering rejected because of Cucm's host name didnt identified at DNS so E20 cant reach DNS correctly
I changed cucm's host name as Ip_adress of CCUM than tried to connect with Auto-register option Than everthing come back Green .)
So I can say for solution of rejected issue , Be sure proxy adress of E20 is configured correctly!!
thanks
Kaan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: