Cisco Jabber for Windows in Extend and Connect mode and making outbound calls
I've set up Cisco Jabber for Windows to use Extend and Connect to control a remote PBX endpoint. I've configured the required CTI-RD device, remote destinations, associated the users to the line and added the devices to end-user controlled device. The extend and connect part is working flawlessly without any issues. I'm able to receive inbound calls on the remote PBX endpoint and control the call (hold, resume, transfer etc.) using the Jabber call window that pops up.
However, I'm unable to make any outbound calls via the Jabber client when in extend and Connect mode. Reading the Extend and Connect guide, I need to configure Dial Via Office (DVO) Reverse. So when the user initiates a Dial-Via-Office reverse call, CUCM calls and connect to the Extend and Connect device (CTI-RD). CUCM then calls and connects to the number the user dialled and finally connects the two call legs.
After attempting to configure DVO-R for Jabber for Windows in Extend and Connect mode following the CUCM feature services guide, i'm unable to get any outbound calls working. From RTMT, i am receiving the following Termination Cause Code: (27) Destination out of order. What i also notice is that there is no calling number for that trace either. I would've thought that the calling party would've been the Enterprise Feature Access (EFA) number.
Has anyone got this working or can provide some guidance?
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...