05-31-2018 01:11 AM - edited 03-17-2019 12:55 PM
Hi Guys,
I see a buggy behavior, where i can see router is generating SIP message on debug but not transmitting it on interface level.
IOS version Version 15.2(4)M4
Hardware 2911/k9
Ran some debug and wireshark to confirm this.
debug voip ccapinout
debug ccsip messages
Call Flow: CUCM -> VGW -> FXS port
Debug shows call hitting from CUCM to VGW.
VGW sending 100 Trying and session in progress.
But CUCM does not receive this.
So i captured wire shark from CUCM facing interface and can see that router is not sending any SIP packets, just the transmission from CUCM side.
We have tried rebooting router.
There is SIP source and Media binding.
Still in enabled mode.
Any Advice will be helpful.
Regrads
Solved! Go to Solution.
05-31-2018 02:15 AM
05-31-2018 01:38 AM
05-31-2018 02:15 AM
we found the issue.
it was due to error on routing table.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide