Cisco SBC crashed when editing cac-policy-set table

[Netmart]

Hello,

I was wondering, if there are any known bugs in Cisco SBC concerning "editing the cac-policy-set tables of an active cac-policy-set":

Platform: ASR 1006

Version: asr1000rp2-advipservicesk9.03.12.00.S.154-2.S-std.bin

Case: When editing cac-table nocode of an active cac-policy-set, the SBC slowed significantly down, no new calls could be processed and issuing any commands took several minutes to execute.

Eventually, the SBC had to be reloaded to fix the issue.

Please advise.

Thanks

[Netmart]

Although I found plenty of Bug entries reporting the crash of ASR 1000 series when applying certain show commands, I was not able to find any report about problems when editing active cac-tables.

The following extract is from a Cisco document:

• Note that you can create an entry in an existing table of an active CAC policy set only if the table type is limit all or policy-set. To perform a modification of this type, you must perform the copy-and-swap procedure.
• source: http://www.cisco.com/c/en/us/td/docs/routers/7600/install_config/sbc_config_guide_2/sbc-7600-config-guide/sbc_pol.pdf

Hence, I was wondering, if a crash can be triggered, if one tries to edit an active cac-table.

If this is the case, I would appreciate, if may be someone from Cisco engineers could comment on the SBC's CAC table configuration.

Thanks,