cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4192
Views
0
Helpful
4
Replies

Cisco Switch > Phone > PC Daisy Chain

bwong
Level 1
Level 1

We have a 3500XL with IOS 12.0(5)WC17 that will not configure a daisy chain for a switch > cisco phone > PC connection.

I'm having trouble configuring our switch to run both voice VLAN traffic and our data vlan traffic through a Fast Ethernet port.

On my other switches, I use these commands:

interface FastEthernet0/18

      switchport

      switchport access vlan 4

      switchport trunk encapsulation dot1q

      switchport mode access

      switchport voice vlan 101

      no ip address

      spanning-tree portfast

Vlan 4 is our data network and Vlan 101 is voice.

When I try running those commands and then do a show running-config on the 3500XL this is what I get:

interface FastEthernet0/18

switchport access vlan 4

switchport trunk encapsulation dot1q

switchport voice vlan 101

spanning-tree portfast

The commands "no ip address" and "switchport mode access" don't seem to work.

Anybody have any ideas on how to get this to work?

Thank you for your time!

1 Accepted Solution

Accepted Solutions

Brandon,

Can you try this config for your PHONE/PC ports

!

interface FastEthernet0/18

desc *** PHONE & PC PORT ***

switchport trunk encapsulation dot1q

switchport trunk native vlan 4

switchport mode trunk

switchport voice vlan 101

switchport priority extend cos 0

spanning-tree portfast

no shut

!

Can you also verify that the vlans have been created or propogated to your switch via VTP

show vlan

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

View solution in original post

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame
The commands "no ip address" and "switchport mode access" don't seem to work.

The commands are not "valid".

The 3500XL is a Layer 2-only switch so you can't configure IP address on an interface.  This means the command "no ip address" is not valid.

Interface FastEthernet 0/18 is already in "switchport mode access" (default) because you have one data and one voice VLAN.  The line "switchport trunk encapsulation dot1q" is not being used because the interface is an access port.

Thanks for the response Leolaohoo!

The current config allows for the PC to acquire a 4 address but the phone gets stuck in "Configuring IP" and never boots up properly.

Brandon,

Can you try this config for your PHONE/PC ports

!

interface FastEthernet0/18

desc *** PHONE & PC PORT ***

switchport trunk encapsulation dot1q

switchport trunk native vlan 4

switchport mode trunk

switchport voice vlan 101

switchport priority extend cos 0

spanning-tree portfast

no shut

!

Can you also verify that the vlans have been created or propogated to your switch via VTP

show vlan

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

Thank you for your help Alex, this worked perfectly!