cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
configure & troubleshoot anyconnect
140
Views
0
Helpful
2
Replies
Beginner

Cisco Unified Communications Manager Express Assigning Extension to 7962.

Good Morning All,

 

I am trying to register an extension to a phone as it went faulty and needed replacement. 

Both phones were registered before, so here is what I did:

Capture.JPG

17 wasn't being used and I change the mac address for 12. 

All good for now, however, my Cisco Unified Communications Manager Express does not allow me scroll down to the desired extension as shown bellow. 

I would like to do it through Command Line but I cannot find my way through.

How do you register an extension on a phone through Command Line? 

Thank you in advance for the response. J 

cucme.JPG

2 REPLIES 2
Highlighted
Hall of Fame Cisco Employee

Re: Cisco Unified Communications Manager Express Assigning Extension to 7962.

Read here:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm/cmebasic.html

 

You already have your current configuration for guidance to match against the documentation.

HTH

java

if this helps, please rate
Rising star

Re: Cisco Unified Communications Manager Express Assigning Extension to 7962.

That is simple just add button command in ephone 12. Say you want to configure Ext 205 i.e dn number 19 on this phone. so just add below

ephone 12
mac XXXX.XXXX.XXXX
button 1:19


*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris
CreatePlease to create content