Hello,
we have some Cisco VG320s, controlled in SCCP by a CUCM 10.x.
We would like to know if we can configure the call transfer feature to be implemented without the use of the hookflash.
TIA and regards.
Solved! Go to Solution.
Table 1
AFAIK, you canno't perform transfer without using hookflash.
Br,
Nadeem
Agreed with Nadeem. On loop start systems you need to use hookflash to signal call transfer.
Hello Nadeem,
thank you for your answer.
Could you provide us the reference to an official document, please?
Thanks again and best regards.
Table 1
Thank you Jaime for your contribution! :-)
In the meantime, I already had found this document, but I was hoping that there was another way to make the call transfer without using the hookflash... ;-)
Thanks again! :-)
Best regards.