08-06-2015 01:32 AM - edited 03-17-2019 03:54 AM
Hi,
My installation is:
Germany Telecom (E1) --> (E1) Cisco Voice Gateway H323 (E1- Emulate Network)) --> PBX Siemens (version 3)
When i call of external --> Siemens Phone it's ok.
But when i call Siemens Phone --> external is no good. The siemens send the number digit by digit.
I would like make this (digit by digit) with my voice gateway and i don't find the command.
Thank your help.
08-13-2015 05:05 AM
Hi all,
I have news, the Siemens PBX give me only 3 digits in my serial 0/1/0:15 and not more.
but i call with 10 digits. I not think that the problem is enbloc configuration.
my serial configuration is :
interface Serial0/0/1:15
description SIEMENS
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn protocol-emulate network
isdn overlap-receiving
isdn incoming-voice voice
isdn send-alerting
isdn negotiate-bchan resend-setup
isdn sending-complete
no cdp enable
Have you idea.
08-13-2015 06:48 AM
What are your dial-peers looking like when the Siemens passes the call to the voice gateway outbound?
08-19-2015 05:56 AM
Hi,
I find my problem.
I add on my serial this :
isdn timer T203 30000
isdn timer T310 60000
The Siemens PBX work digit by digit and not enbloc.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide